Table of Contents
Advertisement
Industrial PCs MCR5000
2.3 W
ARRANTY
During the unit warranty period, any repairs thereto must strictly be conducted solely by
the manufacturer or by service personnel that has been duly authorised by the
manufacturer.
2.4 T
REATMENT AND DISPOSAL OF LITHIUM BATTERIES
Warning:
There is an acute risk of explosion should the wrong type of battery be used.
Do not put lithium batteries into fire, do not solder on the cell body, do not recharge them,
open them, short-circuit them, do not reverse their polarity or heat them up over 100°C;
dispose of them properly and protect lithium batteries from direct sun light, humidity and
condensation.
Lithium batteries may only be replaced by the same type or by a type recommended by
the manufacturer.
The lithium battery must be disposed of according to the local legislation at the end of its
life cycle.
Note:
You'll find a detailed instruction on how to replace the lithium battery in the chapter
"Battery replacement".
2.5 S
I
AFETY
NSTRUCTIONS
Warning:
All unit assembly operations must be strictly conducted only under safe, secure and zero-
potential conditions.
Special Note:
When handling parts and components susceptible to electrical discharge, please
accurately observe all the relevant safety provisions.
(DIN EN 61340-5-1 / DIN EN 61340-5-2 refers)
© ads-tec GmbH • Raiffeisenstr.14 • 70771 Leinfelden-Echterdingen
/ R
EPAIRS
11
Advertisement
Table of Contents
