ADS-tec mcr5000 User Manual page 22

Subsequently, the brackets or retainers must be hinged back into place in the provided
eyes on the monitor.
Warning:
You finally have to check, that the monitor is properly installed; this can be done by
visual inspection and by carefully trying to pull the monitor to the front at the bottom
edge.
The locking plate is pushed into the provided holes by using both tabs, as shown in the
figure, and finally pushed into the device until the lock snaps audibly and noticeably into
place.
22
Industrial PCs MCR5000
© ads-tec GmbH • Raiffeisenstr.14 • 70771 Leinfelden-Echterdingen