Advertisement
Installing a Remote-Control Track section
F
ollow these steps and refer to Figure 1 as you install the Remote-Control Track section.
The Operating Track Controller (available separately, 6-14185) is perfect for
Note!
controlling the Remote-Control Track section in the TrainMaster Command Control
environment. Refer to that manual (71-4185-250) for further information.
1. Install the Remote-Control Track section as you would any other track section. Simply insert
the pins at the end of one track section into the openings in the end of the next.
At this point, the O-27 section (6-12746) is fully installed. No additional controller
Note!
wiring is needed.
2. For O gauge track, locate the grooved wire and connect it to the #1 terminal on the
Remote-Control Track section as illustrated in Figure 1.
3. Attach the next wire to the #2 terminal on the track section.
4. Attach the next wire to the #3 terminal on the track section.
5. Attach the remaining wire to the #4 terminal on the track section.
1 2 3 4
Grooved
wire
UNCOUPLE
Figure 1. O gauge Remote-Control Track section installation
UNLOAD
3
Power/A
POWER
SUPPLY
Common/Ground/U
Advertisement
