Cleaning The Motor Block; After Cleaning; Storage - Silvercrest SSM 550 D1 Operating Instructions Manual

GB
CY

Cleaning the motor block

After cleaning

Storage

14
WARNING! RISK OF INJURY!
► Take care with the cutting blades
3) Clean both parts thoroughly in a mild soapy solution or in a dishwasher.
4) Refit the plastic element
Ensure that the sealing ring
1) Use a dry or no more than slightly moistened cloth to clean the plastic
surfaces.
2) When cleaning, always check that the contact switch in the fitting for the
blender is not blocked by soiling residues. If you cannot dislodge any
blockages with the corner of a piece of paper, make contact with Customer
Services. Do not use any hard objects, these could damage the contact
switch.
3) Remove any possible residues on the underside of the motor block
dry cloth or a stiff-bristled brush only. Ensure that nothing can get in through
the ventilation openings of the appliance.
Allow all parts to dry well before reassembling and reusing the liquidiser.
1) If you do not intend to use the blender for an extended period, clean it
thoroughly (see chapter "Cleaning").
2) Wrap the power cable
motor block .
3) Store the blender in a cool and dry location.
. They are very sharp. Risk of injury!
of the blender onto the glass element
is correctly fitted.
around the cable retainer
.
with a
on the base of the
SSM 550 D1