Worx WG154E Original Instructions Manual page 14

WARNING: Use only 1.65mm
diameter cutting line. Other sizes of
line will not feed properly and will result in
improper cutting head function or can cause
serious injury. Do not use other material
such as wire, string, rope, etc. Wire can break
off during cutting and become a dangerous
projectile that can cause serious injury.
FLOWER GUARD (See Fig. E)
Fold the Flower Guard (6) when edging and
unfold it before trimming, as shown in Fig
E.Before trimming or edging make sure the
Flower Guard is locked firmly in position.
TRIMMING (See Fig. E1)
Postion the trimmer head as shown in Fig
E1for trimming.
Keep the bottom of the trimmer head just
above the ground and at an angle. Allow only
the tip of line to make contact. Do not force
trimmer line into work area.
EDGING (See Fig. E2, E3, E4)
ALWAYS REMOVE THE BATTERY
PACK BEFORE ADJUSTING THE
14 TRIMMER HEAD POSITION
For edging, position the trimmer head as Fig.
E2.
To rotate the trimmer head to edging—first
hold the trimmer shaft as shown in Fig. E3--
-then with your other hand hold the trimmer
head - Push down and rotate 180degrees and
then release- the trimmer will then lock into
the edging position automatically—Fig. E4
NOTE: The trimmer head will only rotate in
one direction.
Take extra caution while edging as objects can
be thrown from the trimmer line.
AUTOMATIC LINE FEED SYSTEM
When initially switching ON the trimmer, a
small length of line is fed out.
A 'clattering' noise will be heard when
the lines hit the line cutter. DO NOT BE
ALARMED, this is normal. After a few
seconds the line will be cut to the correct
length and the noise will reduce as the motor
receives full speed.
If the noise of the line being cut can't be
heard, more line will need to be fed out.
To feed more line, it is first necessary to allow
2-in-1 Grass Trimmer/Edger
the trimmer to stop completely, then restart,
allowing the motor to reach full speed.
Repeat above until you hear the lines hitting
against the line cutter.
TO MANUALLY FEED THE LINE
(See Fig. F1)
ALWAYS REMOVE THE BATTERY
PACK BEFORE ADJUSTING THE
TRIMMER HEAD POSITION
If required, line can be feed out manually.
To operate, press and release manual line feed
button (13), while gently pulling out the line
until it is long enough to reach the line cutter.
If the line extends past the line cutter, too
much line has been fed out.
If too much line is fed out, remove the spool
cap and turn spool counter-clockwise until the
line is at the desired length.
TO REMOVE THE CAP (See Fig. F2)
• Press and hold the two latches (9).
• Pull cap away from the spool holder.
• When refitting the spool cap, keep
all areas of the cap and spool holder
clean.
• Replace the cap, pressing firmly down
towards the spool holder to ensure cap is
fully located into position.
• Check that the cap is correctly fitted by
trying to remove it without depressing the
two latches.
REPLACE THE TRIMMER LINE AND SPOOL
(See Fig. G).
ALWAYS REMOVE THE BATTERY
PACK BEFORE ADJUSTING THE
TRIMMER HEAD POSITION
• Remove Spool Cap Cover.
• For your convenience it is recommended
you buy replacement spools with the
trimmer line preinstalled.
• Remove the old Spool from Spool Holder.
Clear any broken line or cutting debris from
the spool area.
• Pull the line from the new replacement
Spool through the eyelet of the Spool
Holder.
• Place new Spool into the holder with the
cut out areas of the Spool facing
inward or down. When installed into
the Spool Holder, the smooth side of
the Spool should be visible.
EN