Worx WG154E Original Instructions Manual page 13

ASSEMBLY
1. ASSEMBLY OF THE MAIN HANDLE
(See Fig. A)
Align and insert the shaft into the upper
housing until a click can be heard. Make sure
the grooves are correctly matched (See Fig. A).
NOTE: Make sure that the handle is
firmly locked in place. Do not try to
remove these pieces after connecting.
2. ASSEMBLY OF THE SAFETY GUARD
(See Fig. B1, B2)
Remove a screw from the guard; attach the
safety guard to the trimmer head. Align the
guard so it slides into the slots located on the
trimmer head. Turn the tool over and secure
the safety guard onto the trimmer head with
the screw (a) provided.
OPERATION INSTRUCTIONS
INTENDED USE
The machine is intended for the cutting of
grass and weeds under bushes, as well as on
slopes and edges that can not be reached with
the lawn mower.
WARNING! The charger and battery
pack are specially designed to work
together so do not attempt to use any other
devices. Never insert or allow metallic objects
into your charger or battery pack connections
because of an electrical failure and hazard will
occur.
1. BEFORE USING YOUR CORDLESS
GRASS TRIMMER
The battery pack included is shipped
UNCHARGED. You must charge before first
use.
The battery charger supplied was designed to
only charge the Li-Ion battery also supplied.
Do not use another battery charger.
2. CHARGING YOUR BATTERY PACK
The Li-Ion battery is protected against deep
discharging. When the battery is empty,
the machine will switch off by means of a
protective circuit: The trimmer head will no
longer rotate .
In a warm environment or after heavy use, the
2-in-1 Grass Trimmer/Edger
battery pack may become too hot to permit
charging. Allow time for the battery to cool
down before recharging.
3. TO REMOVE OR INSTALL BATTERY
PACK (See Fig. C1, C2)
Depress the battery release button to release
battery pack from your trimmer (Fig. C1).
After recharging, insert the battery pack into
trimmer's battery port (Fig. C2). A simple push
and slight pressure will be sufficient until a
click is heard.
NOTE: When removing the battery
pack, hold it firmly to avoid potential
accidents.
4. SAFETY ON/OFF SWITCH (See Fig. D)
The safety switch is locked off to prevent
accidental starting. Depress the lock off button
(2) then depress the on/off switch (3) and
release lock off button. Your trimmer is now
on. To switch off, just release the on/off switch.
WARNING! The cutting head
continues to rotate after the
trimmer has been switched off; wait until
it has completely stopped then lay down
the tool.
OPERATION
WARNING: Always wear the eye
protection. Never lean over the
trimmer head. Rocks or debris can ricochet
or be thrown into eyes and face and cause
blindness or other serious injury. When
operating unit, check for the following:
Wear eye protection and heavy clothing. Hold
front handle with one hand and auxiliary
handle with the other hand. Keep unit below
waist level. Work only from your right to your
left to ensure debris is thrown away from you.
Without bending over, keep line near and
parallel to the ground (perpendicular when
edging) and not crowded into material being
cut.
WARNING: Make sure that line is
fed out before operation. Make
sure motor is up to full speed before
trimming.
13
EN