Philips Sonicare Manual page 3

To connect the handle to the app, turn on the handle by pressing
3
either the power on/off button or the brushing mode button.
Make sure the handle is not on the charger when you turn it on.
Open the Philips Sonicare For Kids app.
4
Follow the app instructions displayed on your smartphone or
5
tablet. The app automatically connects with the toothbrush. If the
toothbrush does not connect, follow the troubleshooting steps
provided in the app.
Keep the smartphone or tablet close to your toothbrush handle
6
when you use your toothbrush. Make sure the smartphone or tablet
is safe in a dry place.
Brushing instructions
Wet the bristles and apply a small amount of toothpaste (about the
1
size of a pea).
Place the toothbrush bristles against the teeth at a slight angle
2
(45 degrees), where the teeth and the gumline meet. This is to ensure
that the whole tooth surface is brushed (Fig. 6).
Press the power on/off button to turn on the Sonicare.
3
Apply light pressure to maximize Sonicare's effectiveness and let the
4
Sonicare toothbrush do the brushing for you (Fig. 7).
Maintain light pressure and gently brush the outer and inner surfaces
5
of all top and bottom teeth while you keep the toothbrush at an
angle such that the toothbrush bristles touch the area where the
teeth and the gumline meet.
The inner and outer surfaces of the upper and lower back teeth are
6
hard to reach. Spend time brushing these areas, apply light pressure
and maintain the angle of the toothbrush bristles to the gum line
(Fig. 8).
Brush the chewing surfaces of all the upper and lower teeth.
7
While you maintain the angle of the bristles to the gum line, gently
8
move the brush head slowly across the teeth in a small back and forth
motion so the longer bristles reach between the teeth. Continue this
motion throughout the brushing cycle (Fig. 9).
Note: To make sure you brush evenly throughout the mouth, divide the mouth
into 4 sections using the KidPacer feature (see chapter "Features").
Begin brushing in section 1 (outside top teeth) a series of musical
9
notes indicate it is time to move to section 2 (inside top teeth).
At the next series of notes move to section 3 (outside bottom teeth).
The next series of notes indicate it is time to move to section 4
(inside bottom teeth). The toothbrush will automatically turn off at
end of the brushing cycle (Fig. 10).
Your Sonicare is safe to use on:
- Braces (brush heads wear out sooner when used on braces)
- Dental restorations (fillings, crowns, veneers)
Brushing modes
The toothbrush automatically starts in the default high mode.
Press the brushing mode button to toggle between modes (Fig. 11).
1
The green mode light indicates the selected mode.
,
- High mode: Full-strength mode designed for older/independent brushers.
- Low mode: Reduced power mode used for training and introducing
younger children to the sonic experience.
Features
KidTimer
- The KidTimer plays a congratulatory sound sequence at the end of the
pre-determined brushing time. Additionally, the KidTimer automatically
turns off the handle when the brushing cycle is complete.
- When in high mode, the KidTimer is set at 2 minutes.
- When in low mode, the KidTimer is set at 1 minute and slowly
increases over time. The progression of time helps young children reach
the dentist recommended 2 minutes of brushing.
Note: Instruct your child to brush until they hear the congratulatory tune and
the toothbrush turns off.
KidPacer
The KidPacer uses a short series of tones to alert the brusher to move to
the next brushing quadrant of the mouth. This ensures that the child's teeth
gets a thorough, overall clean (see "Brushing instructions").
Easy-start
- The Sonicare For Kids comes with the Easy-start feature activated.
- The Easy-start feature gently increases the power over the first
14 brushings.
Note: Each of the first 14 brushings must be at least 1 minute in length to
properly advance through the Easy-start ramp-up cycle.
Deactivating or activating the Easy-start feature
Attach the brush head to the handle.
1
Place the handle in the plugged-in charger.
2
- To deactivate Easy-start:
Press and hold the power on/off button for 2 seconds. You hear 1 beep to
indicate that the Easy-start feature has been deactivated.
- To activate Easy-start:
Press and hold the power on/off button for 2 seconds. You hear 2 beeps to
indicate that the Easy-start feature has been activated.
Note: Using the Easy-start feature beyond the initial ramp-up period is not
recommended and reduces Sonicare's effectiveness in removing plaque.
Cleaning
Do not clean brush heads, handle, charger, charger cover or replaceable
panel in the dishwasher.
Toothbrush handle
Remove the brush head and rinse the metal shaft area with warm
1
water (Fig. 12).
Do not push on the rubber seal on the metal shaft with sharp objects,
as this may cause damage.
Use a damp cloth to wipe the entire surface of the handle.
2
Brush head
Rinse the brush head and bristles after each use (Fig. 13).
1
Remove the brush head from the handle and rinse the brush head
2
connection at least once a week with warm water.
Charger
Unplug the charger before cleaning.
1
Use a damp cloth to wipe the surface of the charger.
2
Storage
- If you are not going to use the Sonicare for an extended period of
time, unplug the charger from the electrical outlet, clean it and store it
in a cool and dry place away from direct sunlight.
Replacement
Brush head
- Replace Sonicare brush heads every 3 months to achieve optimal results.
- Use only Sonicare For Kids replacement brush heads.
Disposal
- This appliance contains a rechargeable battery which must be disposed
of properly (Fig. 14).
- Contact your local town or city officials for battery disposal information.
You can also call 1-800-8-BATTERY or visit www.rbrc.com for
battery drop-off locations.
- For assistance, visit our website www.philips.com/support or call
1-800-243-3050 toll free.
Removing the rechargeable battery
Only remove the rechargeable battery when you discard the appliance.
Make sure the battery is completely empty when you remove it.
- To remove the rechargeable battery, you need a flat-head (standard)
screwdriver. Observe basic safety precautions when you follow the
procedure outlined below. Be sure to protect your eyes, hands, fingers,
and the surface on which you work.
To deplete the rechargeable battery of any charge, remove the handle
1
from the charger, turn on the Sonicare and let it run until it stops.
Repeat this step until you can no longer turn on the Sonicare.
Insert a screwdriver into the slot located in the bottom of the handle
2
and turn counterclockwise until you see a gap between the bottom
cap and the handle (Fig. 15).
Insert the screwdriver into the gap and pry the bottom cap out of the
3
handle (Fig. 16).