Dodge ram truck 3500 1996 Service Manual page 1695

BR
• AUTOMATIC TRANSMISSION—46/47RE 21 - 305
DISASSEMBLY AND ASSEMBLY
(Continued)
(11) Verify that throttle lever is aligned with end
of kickdown valve stem and that manual lever arm is
engaged in manual valve (Fig. 111).
(12) Install boost valve, valve spring, retainer and
cover plate. Tighten cover plate screws to 4 N-m (35
in. lbs.) torque.
(13) Obtain new fluid filter for valve body but do
not install filter at this time.
(14) I f line pressure and/or throttle pressure
adjustment screw settings were not disturbed, con­
tinue with overhaul or reassembly. However, i f
adjustment screw settings were moved or changed,
readjust as described in Valve Body Control Pressure
Adjustment procedure.
SPECIAL
TOOL
6583
POSITIONED
O N DETENT
HOUSING
J952M78
Fig. 110 Detent Ball Spring
NOT serviceable. Do not try to remove the filter a s
this will damage the solenoid valve housing.
CAUTION: DO NOT TURN
THIS SCREW FOR ANY REASON.
DOING SO WILL RUIN
SOLENOID VALVE CALIBRATION
CAUSING FAILURE.
SOLENOID VALVE
O-RINGS
(SERVICEABLE)
SOLENOID VALVE
FILTER (NOT SERVICEABLE)
VENT
PORTS
J9321-455
Fig. 112 Governor Pressure Solenoid
(1) Turn valve body assembly over so accumulator
side of transfer plate is facing down.
(2) Install new O-rings on governor pressure sole­
noid and sensor (Fig. 112) and (Fig. 113).
(3) Lubricate solenoid and sensor O-rings with
clean transmission fluid.
(4) Install governor pressure sensor in governor
body. Then secure sensor with M-shaped retaining
clip (Fig. 113).
RETAINING
CLIP
GOVERNOR
BODY
GOVERNOR
P R E S S U R E
SENSOR/TRANSMISSIO
FLUID TEMPERATURE
• THERMISTOR
MANUAL
VALVE
J9121-54
Fig. 113 Governor Pressure Sensor
Fig. 111 Manual And Throttle Lever Alignment
00VERN0R BODY, SENSOR AND SOLENOID INSTALLATION
CAUTION: Do not turn the small screw at the end
of the governor pressure solenoid valve for any rea­
son (Fig. 112). Turning the screw in either direction
will ruin solenoid calibration and result in solenoid
failure. In addition, the filter on the solenoid valve is