Stopping Charging; Using The Jump Start Function (Boost Mode); Switching The Display; Charging Time - AEG LW 60.0 Instructions For Use Manual

Note:
Once the battery is fully charged, the charger will switch to trickle charge to main-
tain the charging status and protect the battery from overcharging.

Stopping charging

Press the Start-StOP (26) button.

Using the jump start function (BOOST mode)

the charger's jump start function can be used to help start vehicles with a weak
battery.
In very low temperatures or if the battery voltage is below 1.5 V charge the battery
at least 5 minutes before jump starting.
1. Connect the charger as described in section "Connecting the device".
2. repeatedly press the SeLeCt MODe (28) button to select BOOSt mode.
3. Press the Start-StOP (26) button to start the BOOSt mode. Note: the BOOSt
mode can only be started with a connected battery.
4. try starting the vehicle.
Note: try starting for max. 30 seconds. Wait approx. 5 minutes before trying to
start it again to allow the charger and battery to cool down.
5. Press the Start-StOP (26) button to exit the BOOSt mode.
Note: the BOOSt mode will automatically stop after approx. 30 seconds to
prevent damage to the device.

Switching the display

During the charging process you can repeatedly press the
SeLeCt DISPLaY (23) button to show the following parameters:
▪
V = charging voltage (24)
▪
% = battery charge condition (25)
Before charging only the current battery voltage can be displayed, and after charg-
ing only the battery charge condition.

Charging time

a battery's charging time greatly depends on its charge condition and the capacity.
GB
35