D Software Components; Updating Switch Software - HP ProCurve Switch 5406zl Installation And Getting Started Manual

Software Components
N o t e

Updating Switch Software

The Services Module requires switch software version K.13.51 or later to be
installed in the switch. When an update is needed, use the following steps to
update the switch software:
1. Visit the HP ProCurve Web portal at
version number of the latest module-compatible software.
2. Check the version number of the software installed on the switch.
Connect to the switch CLI and use the following command:
hostswitch# show version
Image stamp: ...
date, time
<
K.13.XX
...
Boot Image: Secondary
3. If the switch software is out-of-date, update it:
hostswitch# copy tftp flash <
hostswitch# startup-default secondary config config1
hostswitch# boot system flash secondary
If a CLI command must be aborted, use either Ctrl-C or Ctrl-Z. The difference
between using the two is that Ctrl-Z, unlike Ctrl-C, does not provide any
message indicating that the command was aborted.
There are some conditions when Ctrl-C may not work; in these cases, use
Ctrl-Z.
www. procurve.com
>
source source file name
><
Software Components
Updating Switch Software
D
to check the
> secondary
D-1