Acl Application Failure Without An Error Message; Symptom - HP FlexFabric 12900 series Troubleshooting Manual

Execute the display qos-acl resource command to display the resource usage. If the number of
ACLs to be applied is higher than the value of the Remaining field, resources are insufficient. If the
ACLs are to be applied globally, check the resource usage on all cards.
[Sysname] display qos-acl resource
Interfaces: XGE2/1/0/1 to XGE2/1/0/21, XGE2/1/0/22
---------------------------------------------------------------------
Type
---------------------------------------------------------------------
VFP ACL
IFP ACL
IFP Meter
IFP Counter
EFP ACL
EFP Meter
EFP Counter
Interfaces: XGE2/1/0/25 to XGE2/1/0/48
---------------------------------------------------------------------
Type
---------------------------------------------------------------------
VFP ACL
IFP ACL
IFP Meter
IFP Counter
EFP ACL
EFP Meter
EFP Counter
IFP—Resource usage for inbound traffic.

EFP—Resource usage for outbound traffic.

2. Delete unnecessary ACLs to release resources if the failure is caused by ACL resource insufficiency.
Delete unnecessary ACLs that use Meter or Counter resources if the failure is caused by Meter or
Counter resource insufficiency. If the ACL resources are sufficient, go to step 4.
3. Apply the packet filter or QoS policy again.
4. If the problem persists, contact HP Support.

ACL application failure without an error message

Symptom

The system applies a packet filter or an ACL-based QoS policy to the hardware. However, the ACL does
not take effect.
XGE2/1/0/23 to XGE2/1/0/24
Total Reserved
1024 768
2048 1792
1024 896
1024 896
1024 0
512 0
512 0
Total Reserved
1024 768
2048 1536
1024 768
1024 768
1024 0
512 0
512 0
Configured Remaining
0 256
1 255
0 128
0 128
0 1024
0 512
0 512
Configured Remaining
0 256
1 511
0 256
0 256
0 1024
0 512
0 512
63
Usage
75%
87%
87%
87%
0%
0%
0%
Usage
75%
75%
75%
75%
0%
0%
0%