HP FlexFabric 12900 series Troubleshooting Manual page 74

GigabitEthernet3/3/0/10
GigabitEthernet3/3/0/12
GigabitEthernet3/3/0/14
GigabitEthernet3/3/0/16
GigabitEthernet3/3/0/18
GigabitEthernet3/3/0/20
GigabitEthernet3/3/0/22
GigabitEthernet3/3/0/24
Ten-GigabitEthernet3/3/0/26
MDC mdcB's interface(s):
M-GigabitEthernet1/0/0/0
[Sysname-mdc-2-mdcA]display this
#
mdc mdcA id 2
location chassis 3 slot 3
mdc start
allocate interface GigabitEthernet3/3/0/1 to GigabitEthernet3/3/0/24
Ten-GigabitEthernet3/3/0/25 Ten-GigabitEthernet3/3/0/26
The output shows that the LPU in slot 3 on member device 3 and its interfaces belong to mdcA.
2. Reclaim the LPU in slot 3 on member device 3 and its interfaces from mdcA.
[Sysname-mdc-2-mdcA]undo allocate interface GigabitEthernet 3/3/0/1 to
GigabitEthernet 3/3/0/24 Ten-GigabitEthernet 3/3/0/25 Ten-GigabitEthernet 3/3/0/26
Configuration of the interfaces will be lost. Continue? [Y/N]:y
[Sysname-mdc-2-mdcA]undo location chassis 3 slot 3
[Sysname-mdc-2-mdcA]display this
#
mdc mdcA id 2
mdc start
#
return
3. Assign the LPU in slot 3 on member device 3 and its interface to mdcB.
On the switch, an LPU can belong to only one MDC. You must assign all interfaces on an LPU to
an MDC by using a single command.
[Sysname]mdc mdcB
[Sysname-mdc-3-mdcB]allocate interface GigabitEthernet 3/3/0/1 to GigabitEthernet
3/3/0/24 Ten-GigabitEthernet 3/3/0/25 Ten-GigabitEthernet 3/3/0/26
Configuration of the interfaces will be lost. Continue? [Y/N]:y
[Sysname-mdc-3-mdcB]quit
[Sysname-mdc-3-mdcB]location chassis 3 slot 3
[Sysname-mdc-3-mdcB]display this
#
mdc mdcB id 3
location chassis 3 slot 3
mdc start
allocate interface GigabitEthernet3/3/0/1 to GigabitEthernet3/3/0/24
Ten-GigabitEthernet3/3/0/25 to Ten-GigabitEthernet3/3/0/26
GigabitEthernet3/3/0/11
GigabitEthernet3/3/0/13
GigabitEthernet3/3/0/15
GigabitEthernet3/3/0/17
GigabitEthernet3/3/0/19
GigabitEthernet3/3/0/21
GigabitEthernet3/3/0/23
Ten-GigabitEthernet3/3/0/25
70