Modifying The Ip Address - Patton electronics IPLink 2603 Quick Start Manual

2.2 Modifying the IP address

1. Display current IP interface settings for the IPLink Ethernet LAN port.
ip list interfaces <enter>
IP Interfaces:
ID | Name | IP Address
---|------|----------------|----------|--------------
1 | ip1
----------------------------------------------
2. Modify the IP address for the LAN port according to your network requirements.
ip set interface ip1 ipaddress 10.10.10.5 255.255.255.0
Note The above IP address (
subnet as your PC.
3. Verify the new address is correct and save it in system boot memory.
ip list interfaces <enter>
system config save <enter>
Now you can connect the IPLink to your local IP network and complete the remaining configuration from your
PC using a standard web browser.
3.0 Connect to the local IP network
Connect the IPLink's (green) Ethernet port to the same Ethernet segment as your PC (see
Note The Model 2620 does not have an MDI-X switch, so you must use a cable wired straight-through to con-
nect the Model 2620's Ethernet port to the IP network.
If you have a Model 2603, press the MDI-X switch until the Ethernet Link LED turns on.
PC
Figure 2.
4
| 192.168.200.10 | disabled | <eth1>
10.10.10.5/24)
Connect to Ethernet port
Ethernet port
Connecting the IPLink to the local IP network (Model 2603/K shown)
| DHCP | Transport
is only an example. You must choose an IP address on the same
------
figure
1 0
/ 1 0
0
P o
w e
r
C r
R X
o s
s o
E t
v e
h e
r
r n
e t
M D
I - X
T X
W
A N
MDI-X switch
IPLink 2603 & 2620 Quick Start Guide
2).