Coleman 800ATV-2 Owner's Manual page 32

odometer, to the tripometer, and then to the
hours meter; then it starts the cycle over.
The odometer displays the total distance
traveled by the ATV. The tripometer records
distances for a specific trip and can record
distances from 0 through 999.9 miles.
To reset a trip meter, select it by pressing the
left button, Press left button to switch to small
mileage (Trip), press the right button for a
long time to reset. The tripometer can be
used to estimate the distance that can be
traveled with a full tank of fuel. This
information will enable you to judge the fuel
consumption.
To change the display from miles per hour to
kilometers per hour press the right side button
on the display. This will also change the
Control Functions
displayed mileage from miles to kilometers.
Clock time adjustment
Press the left button and hold for three
seconds and the clock goes into the hour 'set'
mode.
1. Press the right button to set the hour.
2. Press the left button again and the clock
goes into the minute 'set' mode.
3. Press the right button to set the minutes.
4. Press the left button again and the clock
will exit the 'set' mode.
Four-wheel drive indicator " "/ " "
There are two 4WD indicators on the display
panel. The left 4WD indicator has a blinking
circle on the front axle when the grey and
4-5