Motion Detection - EverFocus eqn2200 User Manual

5.7.2 Motion Detection

Motion Detection
Users can define the motion areas to be de
the start point. Then click the mouse again at the end point, a rectangle will be
formed as the motion detection area.
Press Update Image to update the current image.
Pres s Select All to have the entire screen selected for motion detection.
Press Clear All and click on the rectangle, to clear that rectangle.
ser and click on the selected rectangle to remove
Press Era
T here are 4 possible motion trigger areas, which can be dist
d ifferent c olors. Check the Enable checkbox to enable event actions related to that
a rea.
F or each area, you can set the event action in response to motion detection in that
area. Event actions can be set in "Event List" section.
In additio n, you can set the Sensitivity level for the motion trigger separately for
each area by selecting from 1 (low), 2, 3, 4, 5, 6, 7, 8, 9 to 10 (high).
Press Apply to apply the setting changes or Reset to reset without saving the
change.
tected by left clicking the mouse to set
32
EQN2200/2201
the selection.
inguished by 4