Telescopic Runners - KKT KOLBE EB8401ED User Manual

Care and cleaning

Telescopic runners

To clean the side walls of the oven, the telescopic slide rails
can be removed. With a large screwdriver loosen the fastening
screws and remove the complete set.
The telescopic drawer slides do not immerse in water and
do not clean in the dishwasher, but cleaned with standard
cleaning agents outside.
Note: The roles must not be greased. After
!
cleaning, the telescopic slide rails and fix it down
with the screws.
Please note:
Telescopic slide rails can not be used with catalytic metal
sheets in the oven!
Replacing the lamp and clean the glass cap
In the lamp bulb is a particularly heat-resistant mold (230 V, 25 W).
To replace this, proceed as follows:
• Disconnect in any case the device from the power supply (pull
the plug or remove the fuse), because the wording could be live.
• To remove the glass cover, hold the lower end with one hand, insert
a flat sharp object, such as a knife between the glass and the frame.
• If necessary, replace the halogen bulb with a 25 watt, 230 V - 300
degree heat resistant - oven lamp.
• Always use a cloth when handling a halogen lamp, in order to avoid
oil stains on the surface.
• Reset the glass cover.
Remove the hook in racks
Remove accessories such as rust and baking sheet.
Hook in racks at the clamping point slightly push down (2 in
figure) and the oven wall down.
Swivel hook in racks inside and unhook at the top (1 in figure)
Insert hook in racks
Insert the siderails up in the holes and swing it down.
At the terminal point, push the spine down slightly and press
toward the side wall.
The hook in racks must engage tight.
15