Using A Handset As A Room Monitor - Swisscom Aton CL315 User Manual

Deactivating the wake-up call/
repeating after a pause (Snooze mode)
Prerequisite: A wake-up call is sounding.
Press the display key. The
§OFF§
wake-up call is deactivated.
or
Press the display key or any
§Snooze§
key. The wake-up call is deacti-
vated and then repeated after
5 minutes. After the second
repetition the wake-up call is
deactivated completely.
Using a handset as a
Room Monitor
If the Room Monitor is activated, a previ-
ously saved destination number is called
as soon as a set noise level is reached. You
can save an internal or external number in
your handset as the destination number.
All of the handset keys are deactivated,
with the exception of the display keys.
The Room Monitor call to an external
number is terminated after approximately
90 seconds. The Room Monitor call to an
internal number (handset) is terminated
after approximately 3 minutes (depending
on the base). When the Room Monitor is
activated, all keys are locked except the
end call key. The handset's speaker is
muted.
When the Room Monitor is activated,
incoming calls to the handset are indi-
cated without a ringtone and are only
shown on the screen. The display and key-
pad are not illuminated and Advisory
Tones are also turned off.
If you accept an incoming call, the Room
Monitor is suspended for the duration of
the call, but the function remains acti-
vated.

Using a handset as a Room Monitor

If you deactivate then reactivate the hand-
set, the Room Monitor remains activated.
Warning!
u
Always check the operation of the
Room Monitor before use. For
example, test its sensitivity.
Check the connection if you are
diverting the Room Monitor to an
external number.
u
When the function is switched on,
the handset's operating time is con-
siderably reduced. If necessary,
place the handset in the charger.
This ensures that the battery does
not run down.
u
Ideally the handset should be posi-
tioned 1 to 2 metres away from the
baby. The microphone must be
directed towards the baby.
u
The connection to which the Room
Monitor is diverted must not be
blocked by an activated Answering
Machine.
Activating the Room Monitor and
entering the destination number
É
¢ ¢
v
Room Monitor
¤
You can enter data in the following
fields:
Activation:
Select to activate.
On
Alarm to:
Select Internal or External.
External number: Select the number
from the Directory (press display key
ö
) or enter it manually.
Internal number: Select display key
¢
. Select handset or
§Change§
call all registered handsets
In idle status, the destination number
or the internal destination number is
displayed.
Sensitivity:
Select noise level sensitivity
High).
to
Call All
¢
.
§OK§
(Low or
39