Related Manuals for Patton electronics 1015
Summary of Contents for Patton electronics 1015
- Page 1 DB-15 Async Short Range Modem SALES OFFICE Part# 07M1015-B (301) 975-1000 Doc# 024011UB TECHNICAL SUPPORT Revised 5/24/94 (301) 975-1007 http://www.patton.com...
-
Page 2: Radio And Tv Interference
19.2 Kbps. The Model 1015 is compatible with the Model 1000, 1005, 1006, 1009 and other Patton short range modems. Measuring only 2.6” x 1.3” x .75”, the Model 1015 is housed in a pop-open ABS plastic case. It is equipped with a male or female DB- 15 connector and a choice of interfaces (RJ-11 jack, RJ-45 jack or ter- minal blocks with strain relief). - Page 3 The Model 1015 is designed to be easy to use. There are no internal jumpers or configuration switches to set, so there is no need to open the case to configure the unit (you may need to open the case for wire connection—refer to section 4.0).
- Page 4 4.1.2 TWISTED PAIR CONNECTION USING TERMINAL BLOCKS If your RS-232 application requires you to connect two pairs of bare wires to the Model 1015, you will need to open the case to access the terminal blocks. The following instructions will tell you how to open the case, connect the bare wires to the terminal blocks, and fasten the strain relief collar in place so that the wires won’t pull loose.
- Page 5 “G” on the terminal block. To avoid ground loops, we recom- mend connecting the shield at the computer end only. A ground wire is not necessary for proper operation of the Model 1015. 7. When you finish connecting the wires to the terminal block, the assembly should resemble the diagram below: of the telephone wire and press together very lightly.
- Page 6 DB-15 port of the RS-232 device. After doing so, remember to insert and tighten the two captive connector screws. Note: If you must use a cable to connect the Model 1015 to the RS-232, make sure it is a straight through cable of the shortest possi- ble length—we recommend 6 feet or less.
-
Page 7: Block Diagram
BLOCK DIAGRAM...