Advertisement
10. TIP the top half of the case as necessary to place it over the
strain relief assembly. Do not snap the case together yet.
11. Insert one captive screw through a saddle washer and then
insert the entire piece through the hole in the DB-15 end of the case.
Snap that side of the case closed. Repeat the process for the other
side. This completes cable installation.
4.2 CONNECTION TO THE RS-232 INTERFACE
Once you have configured the Model 1015 for DTE or DCE and
connected the twisted pair wires correctly, simply plug the 1015 directly
into the DB-15 port of the RS-232 device. After doing so, remember to
insert and tighten the two captive connector screws.
Note: If you must use a cable to connect the Model 1015 to the
RS-232, make sure it is a straight through cable of the shortest possi-
ble length—we recommend 6 feet or less. The Model 1015 requires a
cable that incorporates pins 1, 2, 3, 4, 9, 10, 11 and 12.
4.3 OPERATING THE MODEL 1015
Once the Model 1015 is properly installed, it should operate trans-
parently—as if it were a standard cable connection. Operating power
is derived from the RS-232 data and control signals; there is no
"ON/OFF" switch. All data signals from the RS-232 interface are
passed straight through. All control signals from the RS-232 interface
are looped back.
Note: If your system requires hardware flow control, you will need
the Patton Model 1012 or Model 1060 Short Range Modem. Call
Patton Customer Service at (301) 975-1007 for more information.
9
PATTON MOCEL 1015 SPECIFICATIONS
Transmission Format: Asynchronous
Data Rate:
0 to 19,200 bps (no strapping)
Surge Protection:
600W peak power dissipation at 1 mS
(10 x 1000 µs exponential waveform) and
response time of 1.0 pS
Control Signal:
CTS (Pin 10) turns ON immediately after
the terminal raises RTS (Pin 2); DSR (Pin 3)
turns on when powered up; DCD (Pin 12)
turns on immediately after the terminal
raises DTR (Pin 4)
Transmit Line:
4 wire, unconditioned line (2 twisted pairs)
Transmit Mode:
Full duplex, 4-wire
Transmit Level:
0 dBm
Line Connection:
RJ-11 or RJ-45 jack or 5 screw terminal
posts (4 wires and 1 ground) and a strain
relief insert
Power Supply:
No external power required, uses ultra low
power from EIA data and control signals
Size:
2.6" x 1.3" x 0.75"
10
Advertisement
