Wireless Mode - Hootoo HT-IP211HDP Quick Start Manual

2.2 Wireless mode

Note:
Before setting the camera to wireless mode, please make sure you have
followed the previous instruction to set the wired mode.
1) After login the web setting page, click on "Parameters" at the
top of the page
2) Click "Wifi", then click "Search" to scan nearby wireless network
3) Select the wireless network you wish to connect to. Enter the
password, and then click "Select"
4) Once the page shows "Connected Success!", click "Apply"
5) Pull out the network cable from the connected camera.
6) Open the IPCSearch software again. Click "Search" to find the
camera. It may take up to 10 seconds for the result to show.
7) Double click on the new IP address. This will lead you to the login page
of the HT-IP211HDP web setting page in your default browser.
8) Use the default username and password "admin" to login
07/08