Setup Via Wps (Wps Router Required) - Hootoo HT-IP211HDP Quick Start Manual

9) Go back to home page, press "cameras". You will see the added
camera shows up. Click the"
10) At this point, the camera has just connected to your cell phone via its
own AP signal. It's not connected to the wireless network from your
router yet. So we need connect it to your router.
11) In MyCam Pro App, go back and press the icon to access setting
page, select "advanced setting" > "Wi-Fi setting" > "SSID"
12) Select the Wi-Fi network of your router, enter its password, and then
press OK. Now your camera has been connected to the Wi-Fi network
from your router. (Online)
" to see live video
In the Wi-Fi setting of your cell phone, connect to the same Wi-Fi network.
Then open HooToo MyCam Pro app > cameras > "
your camera now.
Note:
・ Please set up the wireless connection from web setting page if you
could not make it work from phone APP
・ If you can't set up wireless connection in HooToo Mycam Pro app,
please login camera's web and configure it

4.2 Setup via WPS (WPS router required)

If you have a router with WPS function, it is much easier to connect this
camera with your router.
1) Power on your camera and Wi-Fi router (with WPS function)
2) Press the WPS button on router once and the WPS indicator stars blinking
3) Press the WPS button on the back of the camera (near the antenna)
for 3 seconds and then release it
4) Wait 8-10 seconds until you see the WPS indicator on router is solid on. It
means your router has connected to HT-IP211HDP camera successfully
5) Open HooToo MyCam Pro app > "add camera" > follow the previous
instruction of Setup via AP mode
Note:
You can also open "IPCamClient" installed on your PC, then follow the
instruction of IPCamClient (software). (Please make sure your PC has
already connected to your router's Wi-Fi network)
", you can view
21/22