Sharp PC-1403 Operation Manual page 125

119
If only the starting line number is specified, that line number alone is del e ted.
If the starting line number and comma(.) are specified, the starting l i ne number and
all the subsequent line numbers are deleted.
If the comma (,) and ending line number are specified, all the lines from the beginning
of the program to the ending line number are deleted.
If both the starting and ending line numbers are omitted, an error occurs.
When the DELETE command is executed while a program fil e is qeing r~8:_d' . pa$e
the MERGE command, the DELETE command
w6r1<$ dn· t f.t~
1 ~ r~1 ' . ·
i. ~.
The ~~LETE command is ignored w~~ any pas~o}dt~
Je .
.j,, ~;
f
I
1~1'
1£0].Jtj
t
t .•
•' - r
-=t~
DELETE 100, Deletes line 100 and all the subsequentline
num· e .
11111
If both the starting and ending line numbers are specified, all the program l i nes between
the two numbers inclusive are deleted. If either of the two specified line numbers is not
found, an error occurs.
•A!iM¥11
The DELETE command is used to delete a program line or program lines. This
command is effective for manual operation in the PROgram mode.
1 DELETE [starting line number][,[ending line number]]
Abbreviations: DEL., DELE., DELET.
See also: NEW, PASS
Commands
DELETE