Sharp PC-1403 Operation Manual page 113

107
1. Recording (saving) onto magnetic tape
See Tape Notes.
(1)
Turn off the REMOTE switch on the CE-126P.
(2) Enter a program or data into the computer.
(3) Load a tape into the tape recorder.
Determine the position on the tape where you want to record the program.
• When using a tape, be sure the tape moves past the clear leader (nonmagnet-
ic mylar material).
• When using a tape already partially recorded, search for a l o cation where no
recording exists.
(4)
Connect the Interface's red plug to the tape recorder's MIC jack and the black
pl u g to the REM jack.
(5) Turn on the REMOTE switch.
(6) Simultaneously press the RECORD and PLAY buttons on the tape recorder (to
put it in RECORD mode).
(7)
Input recording instructions (CSAVE statement, PRINT# statement), and
press the
I
ENTER
I
key for execution.
First set the computer in the "RUN"
or
"PRO" mode. Next operate the
following keys:
w
w
m
CY] [TI
I
SHIFT
I
C'.:.l
fil e name I
SHIFT
I
C'.:.l
I
ENTER
I.
(To write the contents of data memory onto tape, operate keys as follows: e.g.,
rn oo co oo rn
1SHIFT1
oo
1ENTER1 .
e.g.,
w m m
rvi T
ISHtFTI
~[A] [A]
!SHIFT!~
IENTERI)
When you press the
I
ENTER]
key, tape motion will begin, leaving about an 8-
second no-signal blank. (A long pip sounds for a while at the beginning.) After
that, the file name and its contents are recorded (with continuous short beep
sounds).
(8) When the recording is complete, the PROMPT symbol(>) will be displayed and
the tape recorder will automatically stop. Now you have your program on tape (it
still is in the computer also).
When data is to be automatically recorded by program execution (PRINT#
statement, not manual operation), set up steps (1) thru (6) before executing
the program.
To aid you in locating programs on tapes, use the tape counter on the recorder.
Using the Options