Pride Mobility 613 Owner's Manual page 38

V I I . C A R E A N D M A I N T E N A N C E
ABS PLASTIC SHROUDS
 The front tiller shroud, front shroud, and the rear shroud are formed from durable ABS plastic and are
coated with an advanced formula urethane paint.
 A light application of car wax will help the shrouds retain their high gloss.
AXLE BEARINGS AND THE MOTOR/TRANSAXLE ASSEMBLY
These items are all prelubricated, sealed, and require no subsequent lubrication.
MOTOR BRUSHES
The motor brushes are housed inside of the motor transaxle/assembly. They should be inspected
periodically for wear by your authorized Provider.
CONSOLE, CHARGER, AND REAR ELECTRONICS
 Keep these areas free of moisture.
 Allow these areas to dry thoroughly if they have been exposed to moisture before operating your
scooter again.
BRAKE PADS
The brake pads on your scooter should be inspected periodically for wear. Once the pads reach 2 mm or
1/16-th of an inch in thickness, they should be replaced. If any of the brake pads needs to be replaced, then
it is best to replace all the brake pads at the same time. Contact your authorized Provider for more
information on replacing the brake pads.
FUSE REPLACEMENT
In the event a fuse should cease to work:
1. Remove the fuse by pulling it out of its slot.
2. Examine the fuse to be sure it is blown. See figure 28.
3. Insert a new fuse of the same rating.
WARNING! The replacement fuse must
exactly match the rating of the fuse being
replaced. Failure to use properly rated
fuses may cause damage to the electrical
system.
38
IDENTIFICATION KEY
1. WORKING FUSE
2. BLOWN FUSE (REPLACE)
1
Figure 28. Fuse Replacement
Full-size Scooter Series
2