Pride Mobility 613 Owner's Manual page 37

V I I I . C A R E A N D M A I N T E N A N C E
WHEEL REPLACEMENT
If your scooter is equipped with pneumatic tires
and you have a flat tire, you can have the tube
replaced. Contact your authorized Provider for
information regarding replacement wheels for
your scooter.
WARNING!
scooter should only be serviced/
replaced
technician.
WARNING! Be sure that the key is
removed from the key switch and
the scooter is not in freewheel
mode before performing this pro-
cedure.
WARNING!
pneumatic tire, remove only the
lug nuts, then remove the wheel.
If any further disassembly is
required,
COMPLETELY or it may explode.
Follow these easy steps for a quick and safe
repair for pneumatic tires:
1. Remove the key from the key switch and
ensure your scooter is not in freewheel mode.
2. Elevate the side of the scooter of which you
are removing the tire. Place wooden blocks
under the frame to elevate the scooter.
3. If you are replacing the tube, deflate the tire
completely before taking it off the hub.
4. Remove the lug nuts from the hub. See
figure 26.
5. Remove the drive wheel from the axle.
6. Remove the screws and separate the rim
halves. See figure 27.
7. Remove the old tube from the pneumatic tire
and replace it with a new tube.
8. Reassemble the rim halves.
9. Slide the wheel back onto the hub.
10. Reinstall the lug nuts and tighten.
WARNING! Make sure all the lug
nuts are tightened properly.
11. Inflate pneumatic tires to the psi/bar/kPa air
pressure rating indicated on each tire.
12. Remove the blocks from beneath the scooter.
Full-size Scooter Series
Wheels on your
by a qualified
When changing a
deflate the tire
IDENTIFICATION KEY
1. LUG NUTS
2. WHEEL
3. HUB
2
1
Figure 26. Drive Wheel Removal
IDENTIFICATION KEY
1. FRONT RIM HALF
2. TUBE
3. TIRE
4. REAR RIM HALF
5. SCREWS
2
1
Figure 27. Pneumatic Drive Wheel Disassembly/Assembly
3
4
3
WARNING! Completely deflate the
tire before attempting repair.
5
37