Pride Mobility 613 Owner's Manual page 33

V I . D I S A S S E M B L Y A N D A S S E M B L Y
3. Grasp and lift up on the frame release
lever. See figure 23.
4. Lift the front section up until the frame
hooks of the front section separate
from the rear section.
5. Slowly separate the two sections.
ASSEMBLY
1. Position the front and rear sections of
your scooter as shown in figure 23.
2. Use the frame release lever to lift the
front section as you align the frame
hooks of the front section with the
lower frame tube of the rear section.
3. Once the frame hooks are over the
lower frame tube, lower the front sec-
tion and pivot the rear section simulta-
neously. This will engage the frame
lockup automatically.
4. Raise the tiller.
5. Connect the front-to-rear cable.
6. Reinstall the battery spacers if
applicable. See figure 16.
7. Reinstall the batteries to the battery
wells.
8 Connect both battery harnesses. See
figure 14.
9. Secure the battery tie-down strap.
10. Reinstall the battery shroud.
11. Reinstall the seat and rotate it into
place.
Full-size Scooter Series
IDENTIFICATION KEY
1. FRAME HOOK
2. LOWER FRAME TUBE
2
Figure 23. Frame Release Lever
1
33