Pride Mobility 613 Owner's Manual page 31

V . C O M F O R T A D J U S T M E N T S
To install the positioning belt (if required):
1. Remove the seat from your scooter.
2. Place the seat upside down so that you can see the
bottom of the seat base. See figure 20.
3. Use a wrench to remove the two rear bolts that
attach the seat frame to the seat base.
4. Insert the bolt through the appropriate ends of the
positioning belt and then reinstall the bolts and
belt back into the seat bottom.
5. Tighten the bolts.
Metal tab style positioning belt
To adjust the positioning belt for operator
comfort:
1. Insert the metal tab on the right side of the belt into
the plastic housing on the opposite strap until you
hear a "click." See figure 21.
2. Pull the strap on the right side of the belt until it is
secure, but not so tight as to cause discomfort.
To release the positioning belt:
1. Press the push button mechanism on the plastic
housing.
Reusable hook and loop fastener style
positioning belt
To adjust the positioning belt for operator
comfort:
1. Align the two sides of the belt placing the looped-
end side directly above the coarser side ("hook")
of the opposite belt. Press firmly together to
fasten. See figure 21.
To release the positioning belt:
1. Grasp the looped-end side of the belt and pull up
to detach from the other side of the belt.
MANDATORY!
positioning belt is properly secured
to the scooter and is adjusted for
operator comfort before each use.
MANDATORY!
positioning belt for loose parts or
damage, including tears, worn spots,
bent hardware, or damaged latch
mechanisms, dirt or debris, before
each use of the scooter. If you
discover a problem, contact your
authorized Provider for maintenance
and repair.
Full-size Scooter Series
Make sure the
Inspect the
Figure 20. Positioning Belt Bolts
OR
Figure 21. Positioning Belt - Metal Tab Style or
Reusable Hook and Loop Fastener Style
31