Pride Mobility 613 Owner's Manual page 9

Battery Condition Meter
When the key is fully inserted and turned clockwise to power up your scooter, this meter indicates the
approximate battery voltage strength. For further information on battery charging, see III. "Batteries and
Charging."
Status LED
The status LED alerts you to electrical problems that may occur with the scooter. The LED remains
constantly lit while your scooter is on. If your scooter develops an electrical problem, the status LED will
flash a code. See VII. "Basic Troubleshooting" for flash codes.
Key Switch
 Insert the key into the key switch and turn it clockwise to power up (turn on) your scooter.
 Turn the key counterclockwise to power down (turn off) your scooter.
WARNING! If the key is turned to the "off" position while your scooter is in motion, the
electronic brakes will engage and your scooter will come to an abrupt stop!
Mirror Positioning and Adjustment
For information on positioning and adjusting your mirror, see V. "Comfort Adjustments."
Tiller Angle Adjustment
For information on positioning and adjusting your tiller, see V. "Comfort Adjustments."
Handbrake Lever
This lever provides you with emergency stopping power. When
in motion, release the throttle control lever and gently squeeze
the handbrake lever to come to a stop.
The handbrake can be locked and used as a parking brake by
squeezing the handbrake lever fully and moving the brake lock
to the locked position. See figure 1. To release the brake lock,
fully squeeze the handbrake.
WARNING! The handbrake is intended for use as
an emergency brake and/or parking brake only.
Off-board Charger Port
The off-board charger power cord plugs into this port during bat-
tery charging. The off-board charger port will be located on the
tiller. See figure 2.
Electrical System Fuses
Your scooter is equipped with a series of electrical system fuses,
which help protect the off-board charging system, key switch,
and lighting system from receiving an overload of electrical cur-
rent. These fuses are the same type used in automobiles and are
located in a compartment on the tiller. See figure 2.
NOTE: Keep all electrical areas clean and free of moisture and
foreign material.
Full-size Scooter Series
I I . Y O U R S C O O T E R
IDENTIFICATION KEY
1. CHARGER POWER CORD
RECEPTACLE
2. OFF-BOARD CHARGER FUSE
3. KEY SWITCH FUSE
4. LOWER HEADLIGHT FUSE
5. REAR TAIL LIGHTS FUSE
6. LEFT TURN SIGNAL FUSE
7. RIGHT TURN SIGNAL FUSE
3
5
7
Figure 2. Off-board Charger Port/Tiller
Console Fuses
1
2
4
6
9