Pride Mobility 613 Owner's Manual page 30

V . C O M F O R T A D J U S T M E N T S
SEAT HEIGHT ADJUSTMENT—COMFORT SEAT POST (IF EQUIPPED)
To reposition the seat to one of two different heights:
1. Remove the seat from your scooter. Pull upward and hold the seat rotation lever to disengage the seat,
then rotate the seat and lift it off of the scooter.
2. Remove the rear shroud.
3. Push up the seat post boot to uncover the hardware.
4. Push down on the seat post while loosening and removing the shoulder bolt, washer, and nut. See
figure 19.
5. Remove the comfort spring.
6. To raise the seat to the top most mounting hole, insert the height adjustment spacer. To lower the seat
to the lowest mounting hole, remove the height adjustment spacer.
7. Reinstall the comfort spring.
8. Hold the upper seat post at the desired height and match up the locating holes in the lower seat post.
Utilize the top holes for the upper position or the bottom holes for the lower position.
NOTE: When the seat post is mounted in the upper position, you must utilize two spacers.
9. Press down on the seat post while reinstalling the hardware and tightening to 210 in • lb (24 N • m).
10. Replace the rear shroud and the seat.
SEAT SUSPENSION ADJUSTMENT (IF AVAILABLE)
You can loosen or stiffen the seat suspension based on which comfort spring you install.
To adjust the seat suspension:
1. Remove the seat from your scooter. Pull upward and hold the seat rotation lever to disengage the seat,
then rotate the seat and lift it off of the scooter.
2. Remove the rear shroud.
3. Push up the seat post boot to uncover the hardware.
4. Push down on the seat post while loosening and removing the hex head bolt and nut.
5. Remove the current spring.
6. Install the desired spring. See figure 19.
7. Press down on the seat post while reinstalling the hardware and tightening to 210 in • lb (24 N • m).
8. Replace the rear shroud and the seat.
POSITIONING BELT (OPTIONAL)
Your scooter seat may be equipped with an auto-type positioning belt that can be adjusted for operator
comfort. The positioning belt is designed to help support the operator so that he or she does not slide down
or forward in the seat. The positioning belt is not designed for use as a restraining device.
WARNING! The positioning belt is not designed for use as a seat belt in a motor vehicle.
Nor is your scooter suitable for use as a seat in any vehicle. Anyone traveling in a vehicle
should be properly belted into seats approved by the vehicle manufacturer.
WARNING! The positioning belt should be secured at all times. Never allow the
positioning belt to hang or drag on the floor as it may become entangled.
30
Full-size Scooter Series