Disassembly And Assembly - Pride Mobility 613 Owner's Manual

V I . D I S A S S E M B L Y A N D A S S E M B L Y
NOTE: Please check the Scooter Features Table on the inside of the front cover to determine if your
scooter model can be disassembled for transporting or storage purposes.
DISASSEMBLY
You can disassemble the scooter into several pieces: the seat, the rear section, the front section, the
batteries, the basket, and the battery shroud. See figure 22. No tools are required to disassemble or
assemble your scooter, but keep in mind that the disassembled sections of the scooter take up more floor
space than the assembled unit. Always disassemble or assemble your scooter on a level, dry surface with
sufficient room for you to work and move around your scooter—about 5 feet (1.5 meters) in all directions.
Remember that some scooter components are heavy and you may need assistance when lifting them.
WARNING! Do not lift beyond your physical capability. Ask for assistance when
necessary while disassembling or assembling your scooter.
IDENTIFICATION KEY
1. SEAT
2. REAR SECTION
3. FRONT SECTION
4. BASKET
5. BATTERIES
6. BATTERY SHROUD
Figure 22. Disassembled scooter
1. Remove the seat by lifting it straight up and off of the scooter. If you encounter resistance when
removing the seat, disengage the seat rotation lever and swivel the seat back and forth while lifting up
on the seat.
2 Gently pull the battery shroud forward, then lift up and off of the scooter.
3. Disconnect the battery tie-down strap.
4. Disconnect the front-to-rear harness.
5. Unplug both battery harnesses by depressing the tabs and then pulling each harness straight up. See
figure 14.
6. Remove the batteries from the battery wells.
NOTE: If spacers are installed to secure the batteries, remove the spacers for safe keeping until the
scooter is reassembled. See figure 16.
WARNING! Failure to unplug both battery harnesses and the front-to-rear harness prior
to separating the front and rear sections could result in permanent damage to the
scooter.
Frame Separation
1. Arrange the front wheel(s) in a straight forward-facing position.
2. Lower the tiller.
NOTE: The pivoting tiller is equipped with a mechanism that will lock the front wheels in place when
the tiller is completely lowered and secured.
32
1 2
3
4
Full-size Scooter Series
5 6