Display And Failure Codes - CDA ci325 Manual For Installation, Use And Maintenance

Display and Failure Codes

Your machine is equipped with diagnostic systems which monitor
wash progress and will intervene to protect the washing machine in
the event of a fault.
Failure Code
Err1
Err2
Err3
Err4
Err5
Err7
Err8
Er10
EuAr
End
UNb
Probable failure
The door is not shut
properly.
Drainage error, water
not emptied within 6
minutes.
Temperature sensor
faulty or not properly
connected.
Heater error (Appears
at end of a cycle).
Water level not
achieved in 8 minutes.
Height of drain hose is
below 80cm.
Drain hose end is in
water.
Motor Error.
Water level excessive.
Water level sensor
signal error.
Communication failure
between PCB and
motor.
End of wash cycle.
After last rinse cycle
finishes laundry not
completely balanced.
The process to be done
Shut the door properly so that you hear the
click then press the "Start / Pause" button.
If the error persists, unplug the machine, close
the water tap and contact CDA Customer Care.
Clean the filter and check the drain hose for
blockage.
If the error persists, unplug the machine, close
the water tap and contact CDA Customer Care.
Unplug the machine, close the water tap and
contact CDA Customer Care.
Unplug the machine, close the water tap and
contact CDA Customer Care.
Make sure the tap is turned on and water
pressure is normal. If the error persists, unplug
the machine, close the water tap and contact
CDA Customer Care.
Install drain hose within specified range of 80-
100cm.
Ensure the drain hose end is not under water
(to prevent syphoning).
Unplug the machine, close the water tap and
contact CDA Customer Care.
Unplug the machine, close the water tap and
contact CDA Customer Care.
Unplug the machine, close the water tap and
contact CDA Customer Care.
Unplug the machine, close the water tap and
contact CDA Customer Care.
Not a machine fault.
Not a machine fault.
25