Table of Contents
Advertisement
Fault
Excessive foam
in the detergent
drawer.
The washing result is
bad.
The water is drained
from the machine as
soon as it is filled.
No water is seen
in the drum during
washing.
There are residues
of detergent on the
clothes.
There are grey stains
on the clothes.
The spinning
process is not done
or starts with delay.
(**)See the section concerning installations your machine.
Probable cause
Too much detergent has been
used.
Wrong detergent has been used.
The incorrect programme was
selected.
The amount of detergent used is
not correct.
The washing machine is
overloaded, or badly loaded.
The machine is siphoning.
This is not indicative of a fault.
The water is in the lower section
of the drum.
This is not indicative of a fault.
This can be caused by low
temperature wash programmes
or excessive detergent use.
This is not indicative of a fault.
This can be caused by low
temperature wash programmes
or insufficient detergent use.
The washload is out of balance.
Methods of elimination
Press the Start/Pause button. In order to
stop the foam, dilute one tablespoon of
softener in half a litre of water and pour
it in the detergent drawer. Wait 5-10
minutes, then press the Start/Pause button.
Ensure correct detergent dosing for all
washes.
Use only the detergents produced for full
automatic machines.
Select a suitable programme (see the
Programme Table on page 19)
Follow the recommendations from the
detergent manufacturer.
Do not exceed the load capacity, and
ensure the clothes are loaded evenly.
Raise the drain pipe outlet above the
minimum specified. (**)
-
Reduce the amount of detergent, or use
liquid detergent. Alternatively, use the
extra rinse function.
Increase the amount of detergent or the
programme temperature, ensuring the
washload is suitable for the temperature
selected.
Do not exceed the load capacity, and
ensure the clothes are loaded evenly.
35
Advertisement
Table of Contents
