Precautions; Regulatory Warning - SARK 110 User Manual

16 Precautions

1. Never connect the unit to an antenna during a lightning storm. Lightning strikes and
static discharges can damage the unit and may kill the operator.
2. Never apply an RF signal or any other external voltage to the test port of this unit. Doing
so may damage the unit. Note that powerful active transmitters nearby may induce a
high RF voltage on the antenna.
3. The test port is ESD protected; however, static build-up on an antenna may cause
damage to the unit when connected. As a precaution, always discharge the antenna
before connecting and after operation, always disconnect the antenna.
4. This product emits a low power RF signal during its active measurement mode. When
connected to an antenna system, this radiation may cause interference to nearby
communication systems. Connect only for as long is necessary.

17 Regulatory Warning

This equipment is intended for use by radio amateurs in a laboratory environment only.
The product generates and radiates radio frequency energy and has not been tested for
compliance of both EMC and R&TTE directives, which are designed to provide reasonable
protection against radio frequency interference and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio communications
Operation of this equipment in other environments may cause interference with radio
communications, in which case, the user is required to take whatever measures may be needed
to correct this interference at their own expense.
rd
Rev 1.2.6 October 3 , 2015
SARK- - - - 110 SARK 110
SARK SARK 110 110
- 67 - © Melchor Varela – EA4FRB 2011-2015
User's Manual