Problems Check List - SUNWIND 420135 Instruction Manual

PROBLEM PROBABLE CAUSE
Pilot does not Gas valve maybe is OFF
alight LPG
empty
Opening air blocked
Air in supply system
Loose connections
Low gas pressure
Pilot will not Debris around pilot
keep alight Loose connections
Thermocouple does not
work
Gas leak in line
Lack of fuel pressure
Burner does not Pressure is low
alight Openings blocked
Control is not ON
Thermocouple bad
Pilot light assembly bent
Not in correct location
Burner flame is Supply hose is bent or
low twisted
Emitter glows Low gas pressure
uneven Base is not on a level
surface
Thick black Blockage in burner
smoke
Carbon deposit Dirt or film on reflector
build-up and flame screen

PROBLEMS CHECK LIST

Gas Cylinder is
SOLUTION
Press and turn the gas tap in ON
Refill LPG Gas Cylinder
Clean or replace openings
Purge air from lines by pressing the control
knob until you smell gas
Check all fittings
Replace LPG Gas Cylinder with a new one
Clean dirty areas
Tighten connections
Replace thermocouple
Check connections
LPG Gas Cylinder almost empty. Refill LPG
Gas Cylinder
LPG Gas Cylinder almost empty. Refill LPG
Gas Cylinder
Remove and clean openings
Turn tap to ON position
Replace thermocouple
Place pilot properly
Position properly and try again
Straighten hose and perform leak test on
hose
Replace LPG Gas Cylinder with a new one
Place heater on a level surface
Turn off the heater and let it cool.
Remove blockage and clear burner inside
and outside
Clean reflector and flame screen
19