SUNWIND 420135 Instruction Manual page 4

Use only the type of gases and the LPG Gas Cylinder specified by the
-
manufacturer (Butane, Propane or mix of them and specified supply
pressure reported on point "B – Specification").
In case of violent wind particular attention must be taken against tilting of
-
the appliance.
Check that the gas governor seal is fitted and that it is in good condition.
-
All leak tests should be done with a soap solution. Never use an open flame
-
to check for leaks!
The whole gas circuit, flexible rubber pipe, gas governor, pilot and burner,
-
should be inspected for leaks or damage before use and at least one time a
month.
Do not use the appliance until all connections have been leak tested.
-
Do not paint the radiant screen, control panel or top canopy reflector.
-
Turn off the gas tap immediately, if smell of gas is detected.
-
Do not obstruct the ventilation holes of the LPG Gas Cylinder housing.
-
Never transport or move the appliance while it is operating.
-
Close the valve of the LPG Gas Cylinder, or gas governor one if any, all the
-
time after use.
Shut off the valve at the LPG Gas Cylinder or the gas governor before
-
moving the appliance.
Do not move the appliance after it has been turned off until the temperature
-
has cooled down.
Control compartment, burner and circulation air passageways of the
-
appliance must be kept clean.
Frequent cleaning may be required as necessary.
-
The LPG Gas Cylinder valve should be turned off when the heater is not in
-
use.
The gas governor/flexible rubber pipe assembly must be located out of
pathways where people may trip over it or in area where the flexible rubber
pipe will not be subjected to accidental damage.
Any guard or other protective device removed for servicing the heater must
-
be replaced before operating the appliance.
Adults and children should stay away from high temperature surface to
-
4