Installing & Cleaning Cartridge Filter; Installing & Cleaning Foam Sleeve Filter; Troubleshooting - Vacmaster VK1650SWD 950091 Manual

1. Remove power head and place in upside down position.
2. Slide the cartridge filter down over the filter cage and carefully push filter in until it
stops against the power head. (fig.1 & 2)
3. Place filter retainer on top of cartridge filter and tighten down by turning retainer
handle clockwise. (fig.3 & 4)
Removing and Cleaning Cartridge Filter
1. Unlock and remove the filter retainer by tuning retainer handle counter clockwise.
2. Carefully hold and pull the cartridge filter up for removal. (fig.5)
3. Clean the cartridge filter by gently tapping or brushing dirt off. Cleaning should
not be done indoors in living areas. For optimal performance a new filter is
recommended.
4. Install cleaned or new filter into place as instructed above in steps 2 and 3 of
installing Cartridge Filter.
5. Wet filters should be removed and allowed to air dry for 24 hours before installing
onto the filter cage.
1 2
9
I
NSTALLING & CLEANING FOAM SLEEVE FILTER
Installing Foam Sleeve Filter
1. Remove power head and place in upside down position. Follow instructions to
remove cartridge filter.
2. Carefully slide foam sleeve filter down over the filter cage making sure the whole
cage is covered.(fig.1 & 2)
3. Replace the power head on to the container.
Cleaning Foam Sleeve Filter
1. With the removed power head in the upside down position, carefully remove foam
sleeve filter. (fig. 3)
2. Use a mild soap and water solution to wash foam sleeve filter and rinse with clean
3 4
water. (fig. 4)
3. Allow filter to air dry before installing and using again.
1 2
T
ROUBLESHOOTING
Symptom Possible Causes
1) No power supply.
2) Faulty power cord.
Vacuum will not
operate
3) Container full.
1) The PET cartridge
Dust comes out
filter or collection bag
from motor cover.
is missing or damaged.
1) There is a blockage in
Reduced
the nozzle or hose,
efficiency and
or the container inlet.
motor/speed
Or dust filter blocked
vibration.
by fine dust.
3 4
Corrective Action
1) Check power supply – cord,
breakers, fuses.
2) Unplug and check the
power cord. If damaged,
have it repaired by a
professional.
3) Empty container.
1) Attach or replace PET
cartridge filter or collection
bag.
1) Check nozzle, hose and
container inlets for
blockage. Take off the filter
and clean it. Or install new
cartridge filter.