Chapter 7 Routing; Static Route - Paradyne 1740 SHDSL User Manual

2/4-wire router

Hide thumbs Also See for 1740 SHDSL:

Table of Contents

CHAPTER 7

This chapter describes how to set up the static routes and RIP. Click Routing Setup from the Basic menu

bar to configure the routing functions.

7.1

The Static Route Configuration field allows you to add, modify, and delete a static route. Type the

Destination Network ID, subnet mask, and next hop IP and click a button below to perform the requested

function.

The router has no default static route. After an RFC 1483-routed VC is created, a static route as follows

will be created.

Network ID

Subnet Mask

0.0.0.0

Click Routing Setup on the Basic menu bar to access the Routing Setup window. It allows adding,

modifying, and deleting the static routes.

Add:

To add a static route complete the following steps:

STEP 1: Enter the parameters for Destination Network ID, Subnet Mask, Next Hop IP

STEP 2: Click on the ADD button

Modify:

To modify a static route complete the following steps:

STEP 1: Select the entry you wish to modify from the List of Static Routes

STEP 2: Change the parameters

STEP 3: Click on the Modify button

1740-A2-GB20-00

Routing

Next Hop IP

10.0.0.2

July 2004

1740 SHDSL 2/4-Wire Router User's Guide

Table of Contents