Router Mode: Service For Five Static Ip Addresses - Paradyne 1740 SHDSL User Manual

1740 SHDSL 2/4-Wire Router User's Guide
3.2.2

Router Mode: Service for Five Static IP Addresses

To set up the service for five static IP addresses, you need to set up the VC in RFC 1483 Routed mode.
STEP 1: Click WAN Setup on the Basic menu bar.
STEP 2: Enter values for: VPI, VCI, Encapsulation (LLC or VC MUX), Enable NAPT.
VPI
VCI
LLCEncapsulation:
VC Multiplexing:
Enable NAPT
STEP 3: Click on the RFC 1483 Routed option.
18
Enter a value for the vitual path identifier
Enter a value for the virtual channel identifier
With LLC encapsulation, a link control header is added to the
Ethernet packet that identifies the protocol type (Ethernet). This
allows multiple protocols to be transmitted over the ATM Virtual
Circuit.
With VC Multiplexing, no link control header is needed as the
ATM Virtual Circuit is assumed to be carrying a single protocol.
Selecting Enabling NAPT will enable Network Port Address
Translation on the WAN interface.
July 2004 1740-A2-GB20-00