Pppoe - Paradyne 1740 SHDSL User Manual

2/4-wire router

Hide thumbs Also See for 1740 SHDSL:

Table of Contents

1740 SHDSL 2/4-Wire Router User's Guide

STEP 4: Click Save & Reboot on the Basic menu bar to save your settings.

3.2.3

PPPoE

When a VC is set in the PPPoA, the router will auto-detect the Authentication code (PAP or CHAP). The

NAPT and DHCP server functions will be enabled automatically.

STEP 1: Click WAN Setup on the Basic menu bar and enter the following parameters to set up the

PPPoE.

VPI

VCI

LLCEncapsulation:

VC Multiplexing:

Enable NAPT

User Name/Password

Mode

Enter a value for the vitual path identifier

Enter a value for the virtual channel identifier

With LLC encapsulation, a link control header is added to the

Ethernet packet that identifies the protocol type (Ethernet). This

allows multiple protocols to be transmitted over the ATM Virtual

Circuit.

With VC Multiplexing, no link control header is needed as the ATM

Virtual Circuit is assumed to be carrying a single protocol.

Selecting Enabling NAPT will enable Network Port Address

Translation on the WAN interface.

These two fields are used for remote subscriber to log on for

Internet access.

Direct and Auto. If the mode is set to Auto, the PPPoE negotiation

automatically starts when the system identifies any traffic required

to be transferred on the link. When DIRECT is selected the PPPoE

negotiation is started manually.

July 2004

1740-A2-GB20-00

Table of Contents