Auger Motor Cover, How To Remove The Pcb - Kenmore 795.78733.804 Service Manual

3-12 AUGER MOTOR COVER
1) After removing the icemaker remove the (5) stainless
screws holding the auger motor cover, shown in the
picutres below.
2) Grip the bottom of motor cover assembly and pull out it.
3) Disconnect wire harness of motor cover assembly.
There is a auger motor on the back, as shown in the
picture.
3-13 HOW TO REMOVE THE SUB PCB
1) Lift up the Fixed Door Bin to remove.
2) Unscrew one screw fixing the Cover Front and
the Sub PCB.
3) Pull the Cover Front to remove.
4) Insert the (-) screw driver into the center hole of the
| upper Sub PBC, and remove the Sub PCB.
5) Revove two housings connecting to the Sub PCB.
Auger Motor
6) Pull the Sub PCB to remove.
- 16 -