Care And Maintenance; Cleaning After Use; Hour Counter; Thorough Periodic Cleaning - ETS SolarForce 652V User Manual

32 - Care and Maintenance

Cleaning After Use

Clean and disinfect the grills, floor and handles
after each use. Use a non-abrasive disinfectant
cleaner. Wipe the grills and handles with a soft
cloth dampened with disinfectant and wipe dry
with a clean soft cloth. Spray the floor lightly with
disinfectant cleaner and wipe dry. We recommend
Australian Gold® PH Neutral disinfectant cleaner.
Shock hazard.
Disconnect power before removing
any protective covers.

Hour Counter

Your booth is equipped with an hour counter that
tracks how long the unit has been in service,
much like your vehicle's odometer. The hour
counter is located on the top of the right blower,
behind the unit. Use this counter to track lamp
hours and many other time based maintenance
procedures.
WARNING

Thorough Periodic Cleaning

Introduction
The cooling fans draw air through the booth and
over time will cause a dust buildup on the lamps
and reflectors. This will reduce the tanning effec-
tiveness of the unit. When a dust buildup is
observed, it is necessary to thoroughly clean the
inside of the booth.
• Open the grills and remove lamps as described
in Lamp and Grill Replacement.
• With a soft cloth, wipe the entire length of each
lamp to remove any film buildup.
• Clean both sides of the grills with disinfectant
cleaner.
• Wipe the reflectors with a clean damp cloth.
• Reinstall the lamps and grills.
• Replace air filters inside each blower. Replace
with a 12" x 12" x 1" furnace filter.

Mechanical Inspection

Your tanning booth has been built for years of
service. To ensure trouble-free operation through-
out its life, inspect the unit's mechanical integrity
every 400-500 hours of use.
• Inspect the unit's fasteners verifying that all are
firmly in place.
• Inspect door alignment. Adjust hinges so doors
close tightly with an even seam between them.
See Adjusting Hinges.
• Inspect all power cords and connections.