Paradyne Hotwire 5446 Installation Instructions Manual page 8

Installing the Hotwire 5446 RTU
Place the Hotwire 5446 RTU on a flat surface with clearance for the rear connectors.
Procedure
1. Use the supplied RJ11 6-pin interface cable for the DSL connection. Insert one end
of the cable into the jack labeled DSL. Insert the other end into the wall jack labeled
DSL.
Hotwire RTU
DSL
Jack
If the Hotwire 5446 RTU is installed on the same line as POTS, a Hotwire 5038
Distributed POTS Splitter can be used as a filter. One 5038 Distributed POTS
splitter is installed as a filter for each telephone, as shown below. To install the
Hotwire 5038 Distributed POTS splitter, refer to Hotwire 5038 Distributed POTS
Splitter Customer Premises Installation Instructions.
Customer
Premises (CP)
Distributed
POTS Splitter
Distributed
POTS Splitter
Line from
RJ11 Wall Jack
97-15300-01
Distributed
POTS Splitter
Line from
RJ11 Wall Jack
8
Hotwire
RTU
98-15813