Aircraft Information - Cosco Scenera Next Instruction Manual

Vehicle Latch Plates
• Check Latch Plates
Grasp the tongue portion of the latch
plate (the part that goes inside the
buckle) and pull straight out, in line with
the lap belt.
If the latch plate does not slide up and
down the vehicle belt, you have a locking
latch plate. You should not need to use a
locking clip.
Check your vehicle owner's manual to
determine the best way to lock a child
restraint in place and whether the latch
plate or retractor will accomplish this.
29
4358-6590B Scenera NEXT.indd 28-29 4358-6590B Scenera NEXT.indd 28-29
If the latch plate slides up and down on
the belt, and you have an ELR retractor,
you MUST use a locking clip to install the
child restraint. See pages 47-48.
You may not need to use the locking clip
with a switchable or ALR retractor.
Locking Latch
Plate
Sliding Latch
Plate

Aircraft Information

This restraint is certifi ed for aircraft use.
Install the child restraint in a window seat
to avoid blocking the aisle. If the aircraft
lap belt is too short, ask the flight atten-
dant for a belt extender.
Use only on forward facing aircraft seats.
Contact the airline for their specific
policies.
Rear Facing
Aircraft Installation
For rear facing
installation follow
pages 36-38.
Some airlines may ask to see a
label stating that this child restraint is
certified for aircraft use.
There is an airplane
certification label
located on the side of
this child restraint as
shown.
Forward Facing
Aircraft Installation
For forward facing
installation follow
pages 45-46.
5/6/15 3:25 PM 5/6/15 3:25 PM
30