Using A Locking Clip - Cosco Scenera Next Instruction Manual

Convertible car seat
Hide thumbs Also See for Scenera Next:
Table of Contents

Advertisement

Using a Locking Clip

You will rarely need to use a
locking clip except in some older vehicles.
Built-in child restraint locking systems
have been required in vehicles since
1996, and many vehicles had these
features even earlier. Review pages 27-
29 and your vehicle owner's manual to
determine if your vehicle belts require a
locking clip.
If you need a locking clip immediate-
ly, they are likely available at an auto
dealership, an auto store, or where you
purchased this child restraint. You can
also email us at consumer@djgusa.com
or call us at 1-800-544-1108 for one.
A locking clip will not fix all types of seat
belt problems. You
MUST
have a lap and
shoulder belt to use a locking clip.
47
4358-6590B Scenera NEXT.indd 46-47
4358-6590B Scenera NEXT.indd 46-47
For Rear Facing installation, follow
Pages 36-38 Warnings and Steps 1-4
before starting locking clip installation.
For Forward Facing installation, follow
Pages 45-46 Warnings and Steps 1-4
before starting locking clip installation.
1.
Determine Locking
Clip Position
Grasp both vehicle belts
together just behind the
latch plate to mark the
position for locking clip.
Unbuckle the belt.
NOTE:
If the latch plate ends up just at the
belt path opening so you cannot grasp the
vehicle belt at the latch plate, grasp the
vehicle belts on the opposite side of the
child restraint, as close to the latch plate as
possible.
2.
Attach Locking
Clip
Thread both portions
of the vehicle belt
onto the locking clip,
as close to the latch
plate as possible.
3.
Position Locking
If it moves more than 1 in. (2.5 cm),
Clip
try reinstalling the child restraint or try
another seating location.
It should be about
1 in. (2.5 cm) from
When installed rear facing, recheck
vehicle belt's latch
the level line.
plate.
When installed forward facing, make
4.
Rebuckle Vehicle
sure to tighten the tether strap.
Belt
Remove the locking clip when the
seat belt is not being used with a
child restraint.
5.
Check Belt
Tightness
Hold child restraint
at the belt path with
your weakest hand.
Push and pull from
side to side.
48
5/6/15 3:25 PM
5/6/15 3:25 PM

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents