Cosco Scenera Next Instruction Manual page 20

3. Reach Under
Pad and Pull Hook
Across to Opposite
1
Side
2
Do not twist belt.
Belt MUST be in front of buckle strap.
You MUST use the 1st or 2nd buckle
slot.
Do not place belt over child's legs.
4. Finished LATCH
Routing
33
4358-6590B Scenera NEXT.indd 32-33 4358-6590B Scenera NEXT.indd 32-33
5. Place Child
Restraint Rear
Facing in Back Seat
For children who
cannot sit up
unassisted, the level
line on shell MUST
parallel with the ground.
For children who can sit up unassisted,
you may rotate the child restraint to be
more upright.
6. Hook LATCH to
Vehicle Anchor
7. Tighten Belt
Place hand in child
restraint.
Firmly push child
restraint down and
back towards the
be
vehicle seat back
while pulling free end
of belt to tighten.
It may be easier to
pull pad away from
shell and tighten
the belt through the
belt path opening as
shown.
8. Check Belt
Tightness
Hold child restraint
at the belt path with
your weakest hand.
Push and pull from side to side.
If it moves more than 1 in. (2.5 cm), try
pulling the belt tighter, try reinstalling
the child restraint, try another seating
location, or switch to using the vehicle
belts.
continued on next page
5/6/15 3:25 PM 5/6/15 3:25 PM
34