Table of Contents
Advertisement
▶ CLEAR ALL – Cancel the whole area.
● SENSITIVITY – Set the sensitivity of motion detection.
Sensitivity degree : 0 < 1 < 2 < ..... < 9
● ALARM-OUT – Set the alarm-out when motion is detected.
4.2.4.2. SENSOR
● RECORD – Select channel to record when a signal is detected from Sensor.
● TYPE – Select sensor type to match sensor type you have.
● ALARM-OUT – Set the alarm-out when a signal is detected.
4.2.4.3. VLOSS
4.2.4.4. E-MAIL
When below events happen, which will be notified to the registered email address by E-mail. You
can register three email address. Please remind that you can select event type after selecting
Event email is ON.
MOTION
POWER ON
SENSOR
HDD ERROR
VLOSS
If you set the Alarm-out to port1,
Alarm will ring when video-loss occurs in a channel.
It makes alarm-out with video-loss.
- 28 -
Advertisement
Table of Contents
