LAFI-SA IVE-1004D-1008C-1016C User Manual page 25

(1) Select camera.
SET
(2) Select
(3) PTZ control screen of the camera will appear.
(4) Move pan, tilt, zoom in/out to desired point.
(5) Click Advance icon or Press ENTER Key in remote controller to save
Click any other position on screen by mouse or press MENU Key to cancel.
(6) if you like to cancel the setting, please click the CLE icon of the channel will be cleared. If
you click "clear all" icon, all value of channels will be cleared.
NOTE
- System records a certain position of PTZ device.
- Before using this function, please make sure that camera supports preset.
- Total 64 preset points can be saved to each channel.
4.2.2.5. SCAN POINT
● CAMERA – Select a specific camera to set up SCAN points.
● LIST – Create another SCAN list
● PRESET – Select desired preset position.
● CLEAR ALL – Cancel all saved scan points.
NOTE
- In SCAN point menu, you can set up PTZ tour route(SCAN-LIST) using saved PRESET position.
- You can create 4 scan lists for each camera. You should setup PTZ protocol and PRESET
Positions before setting Scan-List.
- You can create Max. 4 SCAN lists.
4.2.2.6. COLOR
Icon.
E.g. In this case,
Camera 1 will move to saved position as follows,
PTZ04 3sec PTZ12
PTZ12 3sec
● CAMERA – Select camera to set up color.
● BRIGHT– Adjust bright of camera.
● CONTRAST – Adjust contrast of camera.
● COLOR/SATURATION – Adjust saturation of camera.
● COLOR/HUE – Adjust hue of camera.
● DEFAULT – Set all values to factory default.
- 24 -
3sec PTZ04
PTZ04 ........
3sec