Table of Contents
Advertisement
SYSEM-ID = 01, Request-ID = 01
Status means that the DVR can be operated or not with the remote controller.
SYSTEM-ID means the number of remote controller ID of DVR.
Request –ID means that the number of Remote controller you have got.
If you like to control the DVR with the remote controller, the value of SYSTEM _ID is the same to
that of Request-ID.
NOTE : You should press two digits when you select System-ID. For example, press 0 + 5, when you
select 05. Don't press only 5. (Please refer to page34 for setting remote control)
3.4. Other function of Remote control
3.4.1. Full screen mode
- Press
button. Whenever pressing
- Press desired numeric button of remote controller.
3.4.2. Quad screen mode
- To see quad screen mode, press
- Whenever pressing
- If you press a numeric key of remote controller which is inside current display range,
selected channel is displayed as full screen mode.
- If you press a numeric key of remote controller which is outside of current display range, the
quad containing selected numeric will be displayed.
E.g. you press 6 while current screen shows CH1~Ch4, CH5~CH8 will be displayed.
1 CAM01
3 CAM03
3.4.3. 9ch display mode – Only for 8 channel DVR
- To see cameras by 9ch mode, press
3.4.4. POP mode : Only for 8 channel
- Press POP button to enlarge specific camera with 7 other cameras.
- Whenever pressing POP button, the biggest screen will change.
3.4.5. OSD Hide or Show
- Press OSD button of remote controller to appear or disappear OSD.
- You can set to hide Status bar only at SETUP menu [SETUP
When there is no command into DVR, Status bar will be hidden.
When you press any button or click by mouse, Status bar will be shown again.
button.
button, screens will go to next quad screens.
2 CAM02
6
4 CAM04
button.
- 15 -
button, screen will go to next screen.
5 CAM05
6 CAM07
7 CAM07
8 CAM08
DISPLAY
OSD]
Advertisement
Table of Contents
