Table of Contents
Advertisement
FIGURE 6
13
STEP 6:
• NOTE: It may be necessary to loosen the 1/2 X 3-1/4" BOLTS of the UPPER CROSS SUPPORT connecting the UPRIGHT
FRAME before beginning STEP 6.
• LOOSELY assemble the TOP BOOM (4) to the UPRIGHT (1) using one 1/2 X 4" BOLT (28), one 1/2 X 3-1/2" BOLT (25), two 1/2"
WASHERS (26), and one 1/2" LOCK NUTS (27) as shown in FIGURE 6.
• LOOSELY assemble the TOP BOOM (4) to the UPPER CROSS SUPPORT using two 3/8 X 4" BOLTS (38), four 3/8" WASHERS (30)
and two 3/8" LOCK NUTS (31). See FIGURE 6.
• Insert one 3 X 2" END CAP (13) into the end of the TOP BOOM (4). See FIGURE 6.
• SECURELY tighten all connections made up to this point.
FIGURE 7
3/8" LOW HEIGHT 29
STEP 7:
• SECURELY assemble the LAT BAR SUPPORT (5) to the TOP BOOM (4) using one 3/8 X 2-3/4" (32) and one 3/8" LOW HEIGHT LOCK
NUT (29). See FIGURE 7.
• Slide two VINYL CAPS (22) over the LAT BAR SUPPORT (5) as shown in FIGURE 7.
UPRIGHT FRAME
31
UPPER CROSS
SUPPORT
30
38 3/8 X 4"
5
22
8
1/2 X 3-1/2" 25
4
28 1/2 X 4"
4
32 3/8 X 2-3/4
27
26
UPRIGHT
Advertisement
Table of Contents
