Table of Contents
Advertisement
UPRIGHT FRAME
FIGURE 2
STEP 2:
• NOTE: It may be necessary to loosen the 1/2 X 3-1/4" BOLTS of the LOWER CROSS SUPPORT connecting the UPRIGHT
FRAME before beginning STEP 2.
• Attach four 3/4 X 1-1/2" GLIDES (24) to the inside of the tube on the UPRIGHT (1) as shown in FIGURE 2 using the follow-
ing steps:
• Thoroughly clean all surfaces where the 3/4 X 1-1/2" GLIDES (24) are to be attached.
• Remove the 3/4 X 1-1/2" GLIDES (24) from the paper backing and firmly apply them to all shown surfaces.
• SECURELY assemble one SPRING PIN ASSEMBLY (21) to the spring pin barrel on the UPRIGHT (1). See FIGURE 3.
• LOOSELY assemble the PULLEY HOUSING (3) and the UPRIGHT (1) to the LOWER CROSS SUPPORT using two 3/8 X 4" BOLTS
(38), four 3/8" WASHERS (30), and two 3/8" LOW HEIGHT LOCK NUTS (29). See FIGURE 2.
• Insert one 2" SQ. END CAP (16) into the end of the PULLEY HOUSING (3) as shown in FIGURE 2.
1/2
0
LOWER CROSS SUPPORT
1/2
1/2
1
2
16
3/8 X 4" 38
30
3
21
3/8" LOW HEIGHT LOCK NUT 29
1/2
1/2
3
4
5
1
24
30
1/2
5
6
Advertisement
Table of Contents
